Applicable scene
Gate valve as a cut-off medium use, in the full open the whole flow straight through, usually applicable to do not need to open and close often, and keep the gate fully open or fully closed conditions, not for use as a regulator or throttling.
Globe valve can prevent the inflow of media or used to regulate the flow rate of media, usually applied to the system needs to regulate or throttle use.

Main differences
1. Structural differences
Gate valve is mainly composed of valve body, valve cover, valve stem, gate, valve seat, sealing filler and transmission device, switch, the gate moves up and down, the flow path in a horizontal line.
Globe valve is mainly composed of valve body, valve cover, valve stem, valve flap, valve seat, sealing filler and transmission device, etc., when switching, the valve flap moves upward, the water flow is low into the high out.
2. Seal different
Gate valve sealing rely on the gate and the valve body for sealing, through the pressure of the medium so that the sealing surface of the pressure; globe valve is through the valve flap in the small trapezoidal side to realize the closure of the seal, through the stem torque to the sealing surface of a downward pressure, relying on the pressure of the valve bar, so that the valve flap sealing surface and the sealing surface of the seat of the valve sealing surface compression, in the sealing force of the globe valve is higher than the gate valve.
The two sealing contact area is different, globe valve in the case of all closed, the valve will be in contact with the sealing surface to each other, the contact area is only the trapezoidal side and the contact surface of the valve flap, as can be seen in the above figure, they are in contact with a very small amount of slippage; while the gate valve in the case of all closed, the need for rafts and the valve body all in contact with the sealing contact area is larger, the relative amount of slippage is larger.

As the sealing contact area of the gate valve is larger, when the medium through the globe valve, for the sealing surface of the wear and tear is greater, when the water quality contains sediment, iron filings, the sealing surface is susceptible to erosion and abrasion, the sealing effect will be greatly affected, especially when the valve is not completely closed, the medium of high-speed scouring of the sealing surface of the erosion of the huge, so that the valve sealing has a great reduction. The globe valve because of its sealing contact area is small, and the sealing surface in the center of the fluid, the impact of water quality is small, the sealing surface is not easy to be eroded and scratched.
Therefore, the sealing effect of the gate valve is not as good as the globe valve.
