Knowledge

What is the difference between swing check valve and lift check valve

Jun 20, 2025 Leave a message

The core differences between the swing check valve and the lift check valve are mainly reflected in the following aspects, and the comprehensive technical data analysis is as follows:

1. Differences in structural principles

Valve disc movement mode

Swing type: The valve disc is disc-shaped and rotates around the shaft outside the valve seat (similar to the rotation of the door leaf around the hinge).
Lift type: The valve disc moves linearly along the vertical center line of the valve body (similar to the up and down movement of the piston).

Typical structural design

The interior of the swing valve body is a streamlined channel to reduce fluid resistance; the lift valve body structure is similar to the stop valve, and the channel direction can be vertical (straight-through type) or in the same direction (vertical type).

2. Performance characteristics comparison

Sealing performance

The lift type has better sealing performance under high-pressure conditions, especially in clean media;
The swing type has weaker low-pressure sealing and is not suitable for pulsating flow media.

Fluid resistance

The swing type has less resistance due to its streamlined design and is suitable for large flow scenarios;
The lift type has greater resistance (straight-through type > vertical type > swing type).
‌Opening and closing speed and response‌

The lifting type has a fast closing speed (depending on deadweight + spring assistance), which can reduce water hammer impact;
The swing type closes slowly, and is prone to hydraulic vibration when large flow backflows.

cryogenic swing check valve
3. Installation and applicable scenarios
‌Installation direction restrictions‌
‌Lifting type‌: usually limited to horizontal pipeline installation (except vertical lifting type); ‌Swing type‌: supports horizontal, vertical (medium from bottom to top), and inclined pipeline installation.

Applicable working conditions

‌Feature‌ S‌wing L‌ift
‌ Diameter Range ‌ Large diameter (DN ≥ 50) Small and medium caliber (DN≤50)
‌Media adaptability‌ May contain trace solid particles Cleaning medium required
‌Stressful scenarios‌ Mainly medium and low pressure Better high pressure sealing

4. Special design variants
‌Swing type improvement‌: The double-flap design accelerates closing through a torsion spring to make up for the response shortcomings; ‌Lifting type expansion‌: The vertical silencer type supports vertical installation and uses soft seals (such as PTFE) to reduce noise.

lift check valve 

Send Inquiry