Knowledge

What is the difference between a check valve and a pressure relief valve

Mar 31, 2026 Leave a message

Check Valve: Allows only unidirectional flow of the medium. It automatically closes when the medium flows in the opposite direction to prevent backflow. Commonly used at pump outlets, boiler systems, etc., to prevent equipment reversal or backflow of the medium.

Relief Valve: Automatically opens to release pressure when the system pressure exceeds a set value, preventing damage to equipment or pipelines due to overpressure. It automatically closes once the pressure returns to normal.

Sourcing Valves? Get Factory-Direct Quotes for Both Relief and Non-Return Valves Today.

 

Comparison Table: Relief Valve vs. Check Valve (NRV)

Feature / Aspect Relief Valve Check Valve (NRV)
Core Definition A valve that automatically releases media when the system is overpressurized. A valve that automatically prevents the reverse flow of media.
Primary Function Safety Protection: Prevents pipes or equipment from bursting due to overpressure. Flow Control: Prevents backflow from damaging pumps, instruments, or causing contamination.
Operating Principle Relies on media pressure to overcome internal spring force. Opens at a set point. Relies on the kinetic energy of the fluid to push the disc open. Closes via gravity or spring.
Flow Path / Design Angular / Bypass: Media is usually discharged to the side or back to a tank. Inline / Wafer: Media passes straight through along the pipeline direction.
Normal Position Normally Closed (NC). Only opens during overpressure events. Normally Open (with flow). Stays open as long as there is positive forward flow.
Key Parameters Set Pressure: The specific pressure at which the valve begins to open. Cracking Pressure: The minimum pressure required to push the disc open.
Installation Site Installed on pressure vessels, pump bypasses, or branch pipes prone to overpressure. Installed at pump outlets, after water meters, or any node requiring backflow prevention.
Response Trigger Responds to changes in Static Pressure within the system. Responds to changes in Flow Direction of the fluid.
Water Hammer Control Helps alleviate some pressure pulsations when opening. Prone to water hammer (especially swing types); silent types can suppress it.
Maintenance Higher. Requires periodic calibration of set pressure and seal checks. Lower. Primarily involves checking disc wear and hinge pin jamming.
Typical Applications Hydraulic systems, storage tank protection, boiler safety assistance. Pump discharge, water heater inlets, chemical injection lines.

 

GNEE valve factory

GNEE Valve Factory

Confused About Valve Specs? Get a Free Technical Consultation and Quick Quote Today.

 

FAQ

When should I use a check valve?

As a safety device, the check valve is important when there is separation between an area of high pressure and one of low pressure. One such circuit is the accumulator, which often employs the use of two check valves.

 

What are the three types of pressure relief valves?

The three basic types of pressure–relief valves are the acting-type pressure relief valve, piston-type pressure relief valve, diaphragm-type pressure relief valve.

 

When would you use a pressure relief valve?

Pressure relief valves are mandatory in pressure vessels, steam systems, chemical processing equipment, and oil and gas operations where overpressure conditions pose significant safety risks. These applications typically involve high-energy systems where failure consequences could be catastrophic.

Send Inquiry