News

Surface Coating Of Valves

Mar 08, 2024 Leave a message

  • Role of Surface Coating

1. Shielding effect
After the metal surface coating, relatively speaking, the metal surface and the environment is separated, this protective effect can be called shielding effect. However, it must be pointed out that a thin layer of coating can not play an absolute shielding effect. Because polymers have a certain permeability, in the coating is very thin, the structure of the pores can make water and oxygen molecules are free to pass. Soft sealing valve on the surface of the epoxy resin coating thickness has strict requirements. It can be seen that for many coatings its value is greater than the steel surface without coating. In order to improve the impermeability of the coating, anticorrosion coatings should be selected from film-forming substances with small permeability and solid fillers with large shielding, while the number of coating layers should be increased so that the coating reaches a certain thickness and is dense and non-porous.
2. Corrosion inhibition
With the help of the internal components of the paint and metal reaction, so that the metal surface passivation or generation of protective substances to improve the protective effect of the coating used for special requirements of the valve must pay attention to the composition of the paint, so as not to cause serious adverse effects. In addition, cast steel valves for oil pipelines, in some of the role of oil and metal soap under the action of the degradation products generated by the catalytic effect, can also play the role of organic corrosion inhibitors.
3. Electrochemical protection
Medium penetration coating in contact with the metal surface under the formation of film electrochemical corrosion. The use of metal in the coating with higher activity than iron as filler, such as zinc. Will play a sacrificial anode protection, and zinc corrosion products are salt-based zinc chloride, zinc carbonate, it will fill the film voids, so that the film is tight, and so that the corrosion is greatly reduced to extend the service life of the valve.

stainless steel plug valve

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

  • Commonly used coatings

1. Valve body epoxy resin coating
It has the following characteristics:
Corrosion resistance
Epoxy resin coated steel has good corrosion resistance, and the bonding strength with concrete is significantly reduced, which is suitable for working conditions in humid environments or aggressive media.
Strong Adhesion
The presence of polar hydroxyl and ether bonds inherent in the sub-chain of epoxy resins gives them a high degree of adhesion to various substances. The low shrinkage of the epoxy resin during curing creates little internal strength and protects the surface coating from peeling off.
Electrical Properties
The cured epoxy resin system is an excellent insulator with high dielectric properties, resistance to surface leakage and arcing.
Mould resistance
The cured epoxy resin system is resistant to most moulds and can be used in harsh tropical conditions.

2. Valve Plate Nylon Plate Material
Nylon plates are extremely resistant to corrosion and are successfully used in many applications such as water, slurries, liquids and desalination.
Outdoor Properties
The nylon plate coating can withstand salt spray tests and immersion in seawater for more than 25 years without the coating peeling off, so there is no corrosion of the metal parts.
Abrasion Resistance
We have very good resistance to soiling.
Impact resistance
There is no sign of peeling under strong impact.

steel valves

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

3. Carbon steel valve plate zero treatment
Provide protection to the substrate metal to prevent corrosion of the metal to a certain extent; used as a primer before painting to enhance the strength of adhesion and corrosion protection of the paint film; used as a friction-reducing lubricant in the cold processing of the metal.

Send Inquiry