News

Installation Steps And Precautions For Wafer Type Butterfly Valve

Nov 14, 2024 Leave a message

Wafer Type Butterfly Valve itself has a small structure. Just place the Wafer Type Butterfly Valve in the middle of the flanges at both ends of the pipeline, use double-headed bolts to go through the pipeline flanges and lock the Wafer Type Butterfly Valve to control the fluid medium of the pipeline. Wafer Type Butterfly Valve is especially suitable for narrow space or short distance between pipelines. When the butterfly valve is in the fully open position, when the medium flows through the valve body, the thickness of the butterfly plate is the only resistance, so the pressure generated by the valve becomes very small, so it has better flow control characteristics.

wafer butterfly valve

  • Pre-installation instructions for Wafer Type Butterfly Valve:

1. Before installation and operation, use air spray to remove foreign objects on the pipeline and clean the inside of the pipeline with water;
2. Check carefully whether the use of the valve is in accordance with its performance specifications;
3. Check the valve channel and sealing surface for debris and remove them in time;
4. After opening the box, the valve should be installed in time. Do not loosen any fastening screws or nuts on the valve at will;
5. Wafer Type Butterfly Valve must use special Wafer Type Butterfly Valve flange;
6. The electric butterfly valve can be installed on the pipeline at any angle. For easy maintenance, it is recommended not to install it upside down;
7. When the butterfly valve flange is installed, make sure that the flange surface is aligned with the sealing rubber, the screws are tightened evenly, and the sealing surface must fit perfectly; if the screws are not tightened evenly, the butterfly plate may be blocked by the rubber protrusions, or the valve stem may leak due to pressure on the butterfly plate.

  • Wafer Type Butterfly Valve Installation Steps:

The correct installation of Wafer Type Butterfly Valve is related to the degree of sealing of the butterfly valve, as well as whether the leakage and other issues, including the safety of working conditions, users should be aware of the installation process.
1.as shown, the valve is placed in the pre-installed between the two flanges, note that the bolt holes should be neatly aligned.

step 1

2. Gently insert the four pairs of bolts and nuts into the flange holes and tighten the nuts slightly to correct the flatness of the flange surface;

step2

3. Fix the flange on the pipe by spot welding;

step3

4. Remove the valve

step4

5. Completely weld and fix the flange to the pipe;

step5

6. Wait for the welding port to cool down before installing the valve. Ensure that the valve in the flange has enough space to move to prevent the valve from being damaged, and ensure that the valve plate has a certain degree of opening;

step6

7. Correct the valve position and tighten the four pairs of bolts (be careful not to over-tighten);

Step7

8. the valve will be opened to ensure that the valve plate can open and close freely, and then make the valve plate open slightly

step8

9. Tighten all nuts in a cross-equalised manner

step9

10. once again to confirm that the valve can open and close freely, note: make sure that the valve plate does not touch the pipeline.

step10

Before installation, Wafer Type Butterfly Valve must be put flat and not collided at will. Wafer Type Butterfly Valve must not be dismantled without special permission in the field piping design after being pulled to the installation length during installation, which is what we should know before installation. At the same time, you should also know that Wafer Type Butterfly Valve can be installed in any position, but after the installation of Wafer Type Butterfly Valve, it is necessary to lay Wafer Type Butterfly Valve along the pipeline and make a bracket for Wafer Type Butterfly Valve. After the bracket is made, it is strictly prohibited to remove the bracket when in use.

Send Inquiry