1. Definition and core structure Basic definition Horizontal swing check valve is an automatic valve that drives the disc to rotate and open and close through the unidirectional flow of the medium. It is designed for horizontal pipelines. The disc rotates around the fixed pin to achieve unidirectional flow control of the medium, effectively preventing backflow and water hammer impact. Core structure Valve disc and pin shaft: The valve disc is a disc or door-shaped structure, which is hinged to the valve body through the pin shaft and can be rotated around the axis to open or close. Some models adopt single-disc, double-disc or multi-disc design to adapt to different calibers (DN≤600 to DN>600) and reduce hydraulic impact. Valve body and seal: The valve body is made of cast steel, stainless steel and other materials, and the flow channel is streamlined to reduce resistance. The sealing surface is a metal hard seal or a rubber/PTFE soft seal, which takes into account both wear resistance and sealing. Working principle and performance characteristics
Working principle
Forward flow : The medium pressure pushes the valve disc to rotate around the pin shaft to open, with extremely small flow resistance, suitable for large flow scenarios .
Reverse flow : When the medium pressure disappears, the valve disc closes quickly under the action of gravity or spring to block the backflow .
Performance characteristics
Low flow resistance : The streamlined design makes the pressure loss significantly lower than that of the lift check valve, suitable for low flow rate and large diameter pipelines (DN≥50) .
Impact resistance : The multi-flap design can disperse the closing impact force and reduce the water hammer effect (especially suitable for DN>600 scenarios) .
Flexible installation : Designed for horizontal pipelines, it can also be installed in vertical or inclined pipelines (the medium needs to flow from bottom to top when installed vertically) .
Limitations :
The sealing performance is weaker than that of the lift check valve, and it is not suitable for pulsating flow or high-frequency opening and closing conditions 16.
Applications
Oil and gas: oil pipelines, tank outlets, etc. to prevent medium backflow.
Municipal engineering: large-scale water pump outlets, water supply networks and other low-pressure large-diameter pipelines.
Industrial systems: medium and low pressure (≤42MPa) fluid control in the chemical and power industries. 48.
IV. Selection and installation points
Selection recommendations
Large-diameter scenarios (DN>600): Multi-flap structure is preferred to reduce the risk of water hammer.
Particle-containing media: Choose carbide sealing surfaces or models with filters.
High-pressure requirements: Choose forged steel valve bodies (such as A105, F11) and surfacing hard seals (Stellite).
Installation specifications
Ensure that the direction of the valve body arrow is consistent with the flow direction of the medium. When installed horizontally, the disc rotation plane must be parallel to the ground.
When installed vertically, the flow direction of the medium (from bottom to top) must be strictly restricted to prevent the disc from being unable to close.
