Knowledge

Factors affecting valve sealing

Feb 20, 2024 Leave a message

  • Seal substructure

Under changes in temperature or sealing force, the structure of the sealing pair will change. Moreover, this change will affect and change the interaction between the sealing pairs, thereby reducing the valve sealing performance. Therefore, when selecting seals, be sure to choose seals with elastic deformation. At the same time, pay attention to the width of the sealing surface. The reason is that the contact surfaces of the sealing pairs cannot completely match each other. When the width of the sealing surface increases, the force required for sealing will increase.

  • Seal surface specific pressure

The specific pressure of the sealing surface affects the sealing performance of the valve and the service life of the valve. Therefore, the specific pressure of the sealing surface is also a very important factor. Under the same conditions, too high a specific pressure will cause valve damage, but too low a specific pressure will cause valve leakage. Therefore, we need to fully consider the appropriateness of the specific pressure when designing.

gate valves

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

  • Physical Properties Of The Medium

The physical properties of the medium also affect the valve sealing performance. These physical properties include temperature, viscosity, and surface hydrophilicity. Temperature changes not only affect the relaxation of the sealing pair and changes in the size of the parts, but are also closely related to the viscosity of the gas. Gas viscosity increases or decreases as temperature increases or decreases. Therefore, in order to reduce the impact of temperature on the valve sealing performance, when we design the sealing pair, we must design it into a thermally compensated valve such as an elastic valve seat. Viscosity is related to the fluid's ability to penetrate. Under the same conditions, the greater the viscosity, the smaller the fluid's ability to penetrate. The hydrophilicity of the surface means that when there is a film on the metal surface, this film must be removed. Because this thin oil film will destroy the hydrophilicity of the surface and cause blockage of the fluid channel.

cteel gate valves

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

  • Quality of seal pair

The quality of the sealing pair mainly means that we have to check the selection, matching and manufacturing accuracy of materials. For example, the sealing surface of the valve disc and the valve seat is very consistent, which can improve the sealing performance. The characteristic of large circumferential corrugations is its good labyrinth sealing performance.

Send Inquiry