Knowledge

What are the common failures of high pressure globe valves

May 22, 2025 Leave a message

  • Seal failure class failure

internal leakage (poor closure)

 

Sealing surface damage: high-pressure media erosion or impurities jamming caused by sealing surface wear, scratches, commonly found in frequent switching of the valve.

Erosion damage: high-speed fluid (such as steam containing particles) scouring the sealing surface to form a groove-shaped marks, reducing the sealing effect.

Impurity jamming: welding slag, rust and other hard particles embedded in the sealing surface, forced to close the sealing surface damage.

External leakage

 

Packing leakage: graphite or polytetrafluoroethylene packing aging, insufficient compression force, or due to deformation of the valve stem leading to seal failure.

Valve body leakage: casting defects, material fatigue or corrosion caused by cracks or sand holes in the valve body, high-pressure conditions to exacerbate the risk of leakage.

high pressure globe valve

  • The operation of the fault

stem jamming

 

Insufficient lubrication: lack of high temperature resistant grease on the stem threads, increased friction under high pressure triggered by stalling.

Packing gland is too tight: excessive compression of packing leads to increased resistance to stem movement.

Can not open and close

 

Foreign matter blockage: pipeline impurities or media crystals accumulate in the valve cavity, hindering the valve movement.

Valve stem deformation: high-pressure impact or external impact leads to valve stem bending, can not be normal transmission.

  • The structure of the damage class failure

seal surface erosion

 

Cavitation effect: fluid vaporisation under high pressure difference to form bubbles rupture, impact on the sealing surface caused by pitting.

Valve body / bonnet cracking

 

Material fatigue: long-term high-pressure alternating load leads to alloy steel valve body cracks.

high pressure globe valve

  • Special working conditions failure

high temperature and high pressure linkage failure

 

Thermal expansion differences: valve body and valve material thermal expansion coefficient is different, easy to jam at high temperatures.

Driver failure (pneumatic / electric valve)

 

Insufficient gas source pressure: pneumatic actuator due to air leakage or pressure reducing valve failure resulting in insufficient driving force.

Send Inquiry