Knowledge

Can wafer check valves be installed horizontally

Apr 17, 2025 Leave a message

‌1. Whether horizontal installation is supported ‌
‌Support horizontal installation‌: Most wafer check valves can be installed horizontally, but it needs to be determined according to the specific structure type. For example: ‌Swing wafer check valve‌: It can be installed horizontally or vertically, but when installed vertically, it is necessary to ensure that the medium flows from bottom to top. ‌Lift wafer check valve‌: Only horizontal installation is allowed, and vertical installation may cause the valve to fail to close normally. ‌Exception‌: If the lift check valve adopts a double-side guide structure (such as a double-guide silencer check valve), it can be adapted to horizontal pipe installation. ‌2. Applicable conditions for horizontal installation‌ ‌Fluid characteristics‌: Suitable for media with low to medium pressure and moderate flow rate. ‌Valve size‌: Small-diameter valves (such as DN≤300) have sufficient closing force when installed horizontally, which can effectively prevent backflow. ‌Maintenance requirements‌: Horizontal installation is more convenient for daily maintenance and component replacement. ‌ ‌3. Notes on horizontal installation‌
‌Direction requirements‌: Make sure that the valve arrow is consistent with the flow direction of the medium, otherwise it may not open and close normally‌.
‌Installation position‌:
Avoid installing in the vertical pipeline with a top-down flow direction. In such scenarios, no check valve is required‌.
The valve cover must face upward for easy disassembly and maintenance‌.
‌Sealing performance‌: When the soft-seal wafer-type check valve is installed horizontally, the pressure resistance and wear resistance of the sealing material must be verified‌.
‌4. Special restrictions on vertical installation‌
‌Flow direction restrictions‌: When installed vertically, the medium is only allowed to flow from bottom to top, otherwise it cannot be closed by gravity‌.
‌Sealing risk‌: Vertical installation may result in poor sealing due to insufficient deadweight of the medium, and a swing-type structure should be preferred‌.

Send Inquiry